PENDING SCCM Built in Bitlocker reports

[PH25]

I'm looking to use the built in BitLocker reports.

View BitLocker reports - Configuration Manager

Learn about the BitLocker management reports in Configuration Manager

docs.microsoft.com

I am running config mgr 2107, so believe they should be there, but I don't see them.

Does anyone know how I make them appear?
I've only just enabled the Bitlocker Management feature. Is this a factor? We do not use config mgr to administer BitLocker but I'm hoping that I can still access the reports. It doesn't look like I have any new reports available since upgrading to 2107.

Thanks!

 

[Garth]

Yes, there are at least 4 bitlocker repot within CM. No the report should be there BEFORE turned on bitlocker. You will need to review the CM reporting point logs to see what the deal is.

 

[PH25]

Thanks Garth. So they should've been created at the time of the upgrade, perhaps? (I think I was previously on a version prior to when they were introduced).

I'm not seeing anything very useful in the logs sadly.

 

[Garth]

Thanks Garth. So they should've been created at the time of the upgrade, perhaps? (I think I was previously on a version prior to when they were introduced).

I'm not seeing anything very useful in the logs sadly.

Reinstall the RP, that should trigger the reports to install again.

 

[PH25]

Is this just a case of removing and then re-adding the role? I did this but no new reports have appeared.

 

[Garth]

Is this just a case of removing and then re-adding the role? I did this but no new reports have appeared.

Did you review the logs to see if there was an issue with them getting installed?

 

[PH25]

Yes, there's no mention of them in the SRSRP.Log file. Lots of references to other existing reports being "Kept", but no mention of anything to do with BitLocker.

 

[Garth]

I have confirmed within my logs that you should see them. if you are NOT seeing them, then it is time to open a support case with MS.