PENDING WINPE not working after upgrading ADK Version

[harveybham]

Hi All,

I did a site upgrade from version 2006 to 2107 which worked fine and has upgraded.
I then upgraded my ADK and WinPe to both have version 10.1.22000.1 (Windows 11 ADK (10.1.22000) )
The server was rebooted after the new ADK and WinPE were installed

I have updated both the x86 and x64 boot image with the new ADK. When i now build a machine the WINpe starts up but seems to restart by itself.
The machine gets an IP address which leads me to believe that the network drivers are ok
I have managed to get the logs from the machine, The errors are



Has anybody seen this before?

 

[Prajwal Desai]

No, I haven't seen this before. Can you remove the drivers from the boot image and re-add them?.

 

[harveybham]

Hi,

I have also done that but still same issue.

I have just noticed that the Current Windows ADK Version and the current production version are different. Should they be the same?

I have ticked the "reload this boot image with the current Windows PE version from Windows ADK" but the version still stays the same (see image)

I have also run a query and it shows the current version (see attached)