PENDING Tabs missing from boot image after updating to ADK 11 and driver update - SCCM 2403

[Emmanuel Okojesu]

I installed the new ADK and WinPE 11 on SCCM and updated the default x64 boot image also with new drivers. However, not all tabs are showing after to update e.g. the driver tab and some others aren't showing again?

 

[Harshit Pandey]

I installed the new ADK and WinPE 11 on SCCM and updated the default x64 boot image also with new drivers. However, not all tabs are showing after to update e.g. the driver tab and some others aren't showing again?

Is this issue for all the boot images?. I guess they haven't been updated properly.

 

[DavidMckee]

Ya as noted from Harshit, you must update your boot images before they are editable (Tabs) after new ADK install

 

[Emmanuel Okojesu]

Is this issue for all the boot images?. I guess they haven't been updated properly.

By updating you mean installing the new ADKs?

 

[DavidMckee]

By updating you mean installing the new ADKs?

No I mean after you install a new ADK you must update all your boot images with new ADK or they will not be editable. As in right click update DP with each image