SOLVED Deployment status doesn't show correctly information

[awachens]

Hi all,
I have some deployments and normally when we check the deployment status we can see how many errors in Completion Statics etc..

Like we can see in the picture, we have 19 errors on this deployment and 95,3% success, but if I click on view status to check what is this error on the 19 device's, we see this:

Only one device on error and the rest with success.

Is this normal?

TIA!

 

[Garth]

Yes this is normal. All it means is that other devices had a problem and have since corrected themselves.

 

[awachens]

Thanks for quick response.
I read it in some forums, but I don't understand why...
I try to explain myself:
When they had a problem? Why they doesn't update the state in Completion Statics? I think my fault is don't understand from where SCCM get this values, you know?
Because, ok they correct themselve, then why doesn't update the state in ALL statics? Only inside deployment status.
What is the difference between both?

Thanks a lot!

 

[Garth]

Thanks for quick response.
I read it in some forums, but I don't understand why...
I try to explain myself:
When they had a problem? Why they doesn't update the state in Completion Statics? I think my fault is don't understand from where SCCM get this values, you know?
Because, ok they correct themselve, then why doesn't update the state in ALL statics? Only inside deployment status.
What is the difference between both?

Thanks a lot!

It likely did update the state; but that does not negate the error that happened before.

The status are been read from the Audit messages. So unless the audit message is deleted and never summarized the errors will exist forever.

 

[awachens]

Morning!!
I think I know why this occurs (in my case).
Maybe is possible that this devices doesn't exist now in the deployment. Then... they failed before but now they aren't in this deployment.

Is this possible?
Regards,

 

[Garth]

Morning!!
I think I know why this occurs (in my case).
Maybe is possible that this devices doesn't exist now in the deployment. Then... they failed before but now they aren't in this deployment.

Is this possible?
Regards,

sure that is possible too.