aissi.nassim
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 1
Hello MECM Expert Team,
I have installed a SUP to deploy updates during the OSD build process. I added a task sequence "Install Software Update". During installation, the CU is detected and installed correctly, but the installation abruptly ends at the end of this task, preventing the subsequent tasks from executing.
Do you have any insights into this issue? Please note that the problem does not occur on virtual machines but does occur on a physical machine, even though I am using the same task sequence.
MECM 2403
I have installed a SUP to deploy updates during the OSD build process. I added a task sequence "Install Software Update". During installation, the CU is detected and installed correctly, but the installation abruptly ends at the end of this task, preventing the subsequent tasks from executing.
Do you have any insights into this issue? Please note that the problem does not occur on virtual machines but does occur on a physical machine, even though I am using the same task sequence.
MECM 2403
Last edited:
