TDA
New Member
- Messages
- 3
- Reaction score
- 0
- Points
- 1
Hello everyone,
I have to set SCCM to use a static ports for WMI instead of dynamic.
FW Guys here will not open the wide dynamic range for WMI.
Without it I can't deploy the Client.
I found out that you can set a stati WMI port (http://plunderingviking.blogspot.ch/2015/03/sccm-dcom-configuration-for-wmi.html or here: http://techboredom.blogspot.ch/2016/08/setting-staticfixed-wmi-port-in-windows.html)
But I don't know if you have to configure this settings on SCCM SRV, on Clients or on both.
Also is this the correct procedure?
I have to set SCCM to use a static ports for WMI instead of dynamic.
FW Guys here will not open the wide dynamic range for WMI.
Without it I can't deploy the Client.
I found out that you can set a stati WMI port (http://plunderingviking.blogspot.ch/2015/03/sccm-dcom-configuration-for-wmi.html or here: http://techboredom.blogspot.ch/2016/08/setting-staticfixed-wmi-port-in-windows.html)
But I don't know if you have to configure this settings on SCCM SRV, on Clients or on both.
Also is this the correct procedure?
Last edited:
