PENDING HELP!! New to SCCM - v1806 (Test Lab Environment) - TS Error

[dgoodrid]

Hi,

I have set up a test home lab for messing around with SCCM etc..

I have a DC and SCCM server (All Virtual) and they can see/talk etc.. to each other and SCCM loads up all ok.

I have added a Custom Wim image on Windows 10 and boot images, driver packages etc... But can't get either a VM or Physical device to build

I have attached a word document with screenshots (Cmtrace error, IP address, Ping server, and the TS showing all 100% on the DP) and also the smsts log in full

As you can see the Packages are all 100% distributed on the DP and that on the VM I get the right IP and can ping anything on that network so but the system just apparently can't find the packages. I have removed the packages and re-added them, and also redistributed them all to no success.

Any suggestions on where to look or what to do would be fantastic

Thanks
Dave
(SCCM Newbee)

 

[dgoodrid]

Sorry files attached

 

[dgoodrid]

No one has any suggestions at all?

 

[Prajwal Desai]

Sorry for the delay, i see that "This task sequence cannot be run because the program files for DEV00008 cannot be located on a distribution point. "

If you're seeing this, it means that the Distribution Point you're talking to is not able find the package referenced. If the package does exist, and/or has been redistributed/verified and the problem persists, then another good place to check, is the Boundary Groups.