PENDING Failing to run Task Sequence 0x800700D

[rymat232]

Hi, I have a device Dell Precision 5820 Tower new out of the box that continues to fail. The specific error message is "Task Sequence "Task Sequence Name" has failed with the error code 0x800700D in the task sequence step 'Partition Disk 0 - UEFI". Below is the smsts log. We have tried the following troubleshooting steps: used diskpart to create UEFI partition, and changed BIOS settings from RAID ON to AHCI and back to RAID ON, and neither of them work. I have attached the smsts log file for review. Any suggestions is appreciated.

 

[Prajwal Desai]

Can you please post the smsts.log and screenshot of the error.

 

[rymat232]

Can you please post the smsts.log and screenshot of the error.

Hi, and thanks for responding. I have attached the smsts log file. I did check the time is set correctly on the clients and MP, as well as DP's

 

[Cid]

Did you make any progress with this? We're having the same problem with this model.

 

[Prajwal Desai]

Can you refer to this article that I just published today - https://www.prajwaldesai.com/fix-sccm-task-sequence-error-0x8007000d/

 

[Robki]

Hi

I also ran into this issue a few days ago.
I fixed it with adding 2 extra drivers into my boot image, they are both included in the official Dell driver package for the Precision 5820

Intel(R) C600+/C220+ series chipset SATA RAID Controller / 7.0.2.1004/ iaStorE.inf
Intel(R) Volume Management Device NVME RAID Controller / 7.0.2.1014 / iaVROC.inf

 

[Cid]

This did the trick for me also. thanks Robki.